SLC27A1 ELISA Kit

Produktnummer ABIN5654096

Ratte SLC27A1 ELISA-Kit Colorimetric-Assay zur Quantifizierung von Ratte SLC27A1.

Kurzübersicht für SLC27A1 ELISA Kit (ABIN5654096)

Target: SLC27A1 (FATP1) (Fatty Acid Transport Protein 1 (FATP1))

Reaktivität: Ratte

Nachweismethode: Colorimetric

Methodentyp: Sandwich ELISA

Detektionsbereich: 0.156 ng/mL - 10 ng/mL

Applikation: ELISA

Proben: Tissue Homogenate

Produktdetails SLC27A1 ELISA Kit

Untere Nachweisgrenze: 0.156 ng/mL

Analytische Methode: Quantitative

Spezifität: This assay has high sensitivity and excellent specificity for detection of Fatty Acid Transport Protein 1 (FATP1). No significant cross-reactivity or interference between Fatty Acid Transport Protein 1 (FATP1) and analogues was observed.

Sensitivität: 0.071 ng/mL

Anwendungsinformationen

Kommentare:

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Testdauer: 3 h

Plattentyp: Pre-coated

Protokoll: The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Fatty Acid Transport Protein 1 (FATP1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Fatty Acid Transport Protein 1 (FATP1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Fatty Acid Transport Protein 1 (FATP1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Fatty Acid Transport Protein 1 (FATP1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Testpräzision: Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Fatty Acid Transport Protein 1 (FATP1) were tested 20 times on one plate, respectively
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Fatty Acid Transport Protein 1 (FATP1) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Beschränkungen: Nur für Forschungszwecke einsetzbar

Handhabung

Handhabung: The Stop Solution is acidic. Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.

Lagerung: 4 °C,-20 °C

Informationen zur Lagerung: -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.

Haltbarkeit: 4-8 months

Details zu SLC27A1

Target: SLC27A1 (FATP1) (Fatty Acid Transport Protein 1 (FATP1))

Andere Bezeichnung: Fatty Acid Transport Protein 1

Hintergrund:

Gene Name: Fatty Acid Transport Protein 1

Gene Aliases: SLC27A1, ACSVL5, FATP, Long-Chain Fatty Acid Transport Protein 1, Solute Carrier Family 27 Member 1,Fatty Acid Transporter

UniProt: P97849

Pathways: Inositol Metabolic Process, Regulation of Lipid Metabolism by PPARalpha